Go Clip Pair: Uses and Setup on a Tool Belt

By Tool Belt Systems for Tradespeople | Diamondback ... | Published: 2026-10-29

Category: How-to Guides

Learn how to attach GoPax and GoSleeves to your Diamondback GoSystem tool belt using a Go Clip Pair. Step-by-step setup guide with common mistakes to avoid.

Quick answer

Use a Go Clip Pair to securely attach GoPax and GoSleeves to your Diamondback GoSystem tool belt. This guide shows you how to install them correctly and avoid common mistakes.

Why Use Go Clips on Your Tool Belt

Go Clips are durable steel accessories that let you add extra storage pouches and sleeves to your GoSystem belt. They provide a stable attachment point without adding bulk or interfering with your existing tool setup.

Unlike permanent stitching or adhesive mounts, Go Clips are removable and repositionable. This is useful if you need to swap out pouches for different jobs or adjust your belt layout throughout the day.

How to Install Go Clips on Your Tool Belt

1. Position the clip on your belt: Slide one Go Clip onto your Diamondback GoSystem belt at the desired location. The clip should fit snugly against the belt webbing without forcing it. Common mistake: placing the clip too close to a buckle or another accessory, which can cause the clip to twist or detach under load.
2. Attach the GoPax or GoSleeve: Align the attachment points on your GoPax or GoSleeve with the slots on the Go Clip. Press firmly until you hear or feel a click, indicating the accessory is locked in place. Checkpoint: If the accessory feels loose, remove it and re-engage the slots. Do not force it—this may damage the clip or the accessory.
3. Repeat for the second clip: Install the second Go Clip at the opposite attachment point of your GoPax or GoSleeve. Use the same positioning method to ensure even weight distribution across your belt. Common mistake: spacing the clips unevenly, which can cause the pouch to sag or tilt while you work.
4. Test the attachment: Gently tug on the attached accessory to confirm it is secure. The Go Clip should hold firmly without sliding or rotating on the belt. Checkpoint: If the clip moves, remove it and check that the belt webbing is not twisted. Reinstall with the clip oriented correctly.
5. Adjust as needed for your setup: To reposition a Go Clip, slide it along the belt to a new location. You do not need to remove the accessory first—just loosen the clip and move it. Common mistake: assuming the clip is one-time use. It is designed for repositioning, but avoid excessive sliding over rough belt edges to prevent wear.

Product facts

Go Clip Pair: Use a pair of durable steel GoClips to attach GoPax and GoSleeves to your Diamondback GoSystem. This product is sold as a pair (2). You get two clips, which is exactly what you need for most attachments—no need to buy extras for a single pouch or sleeve.
Go Clip Pair